Documentation Center

Viz Artist

Version 3.11 | Published August 27, 2018 ©

Flag

images/download/attachments/27789096/viz_icons_flag.png
The Flag plug-in provides a simpler simulation of an elastic vertex object than the Cloth Flag plug-in.

Note: This plug-in is located in: Built Ins -> Geom plug-ins -> Dynamics

This section contains the following topics:

Flag General Properties

images/download/attachments/27789096/plugins_geometries_flag_properties.png

  • Width: Defines the width of the object. Accepted values are from 0.0 to 200

  • Height: Defines the height of the object. Accepted values are from 0.0 to 200

  • Amount: Sets the intensity of the effect. Accepted values are from 0.0 to 200

  • Wavelength: Defines the length between the animated waves. Accepted values are from 0.0 to 200

  • Wave Speed: Defines the speed of the animated waves. Accepted values are from -100 to 100

  • Turbulence Speed: Defines the speed of the turbulence in the animation. Accepted values are from -100 to 100

  • Y Stretch: Defines the anisotropic value of the Y-axis. Accepted values are from 0.2 to 100

  • Tessellation X: Defines the amount of tessellation on the X-axis. Accepted values are from 1 to 100

  • Tessellation Y: Defines the amount of tessellation on the Y-axis. Accepted values are from 1 to 100

  • Plane: Selects the dimensional plane for the rendered object.

  • Fixed Edge: Selects which edge should be fixed, or none. The fixed edge will act as a boundary for the animation.

  • Direction: Automates the animation direction angle if set to Auto (default).

  • Dir Angle: If Direction is set to Custom, provides the designer with the option of defining the animation direction angle. Accepted values are from -720 to 720