AV Automation can send commands to all connected broadcast devices. For the commands to be received, and interpreted according to the device's specifications, the device must be configured within Viz Mosart.

• To configure device properties in AV Automation, select Devices > Properties.

The Device Properties menu has three common buttons:

• Cancel: Exit this menu without saving any changes.

• Apply: Save all changes and reconnect the device on the active tab (only applies to tabs Vision Mixer, Video Servers, Graphics, Audio, Camera Robotics, Light Control and Subtitles).

• Save & Close: Save all changes and close the menu.

This section presents the following device properties:

• Vision Mixer

• Video Servers

• Graphics

• Audio

• Camera Robotics

• Light Control

• Router

• Subtitles

• GPIO

• Tally

• Virtual Set

• Weather

• Video Wall

• General