From AV Automation > Devices > Properties > Camera Robotics tab, you can configure up to 4 robotic camera controllers.

• Use Robotic Cameras: Check to enable the robotic camera control functionality.

• Robotic Camera: CAMBOTICS, CAMEROBOT, CINNEO, ELECTRIC FRIENDS, FX-MOTION, PANASONIC, PANASONICNEW, PANASONIC TCP, SHOTOKU TR-T, SHOTOKU TR-T IP, TECHNODOLLY, TELEMETRICS, VINTEN 200, .

• Host: Hostname or IP address of the RCC (Robotic Camera Controller) server.

• Hosts (FX-Motion and Technodolly): A comma separated list of names or IP addresses for the camera robots starting from Camera 1. Missing robots are indicated by extra commas.

• Port: Port to communicate with the RCC server.

  Note: When using PANASONIC TCP, you may or may not specify a port here. If no port is specified, the default port 80 is used.

• Com port: For serial communication with the RCC server.

  Note: When using PANASONIC or PANASONICNEW you must select the Com port to use. Only one controller can be connected to each Com port.

• Cameras: List of robotic cameras for individual stand-by control and for matching against the Camera Number in Robotic Camera Control in Template Device Functions. List members are separated by commas, or by hyphens indicating ranges.

  Note: When using PANASONIC, PANASONICNEW, or PANASONIC TCP, the connection goes through a controller. The Cameras value is used to set the controller, so only enter one number here.